Total Protection Films
Commercial solar window film, Solar Gard TrueVue 5, giving a dark tinted look to the storefront windows of a commercial space

Commercial Window Tinting

Commercial Solar Window Film

Commercial solar window film is a heat-rejecting film applied to the existing glass of offices, storefronts and other buildings to cut solar heat gain, hot spots and glare along perimeter zones. We install Solar Gard, XPEL and Maxpro solar films across Arizona from $8.25 per square foot, usually after hours.

  • From $8.25 per sq ft installed
  • After-hours and phased installs
  • Published spec data for every film

Overview

Commercial solar window film for Arizona buildings

In an Arizona commercial building, the glass decides how the perimeter of every floor behaves. Offices along a west wall get warm by mid afternoon. Reception desks near a storefront sit in direct sun. Facilities teams hear about it as hot and cold complaints, thermostat battles, and blinds that stay closed all year so nobody can see out.

Solar window film works on the glazing you already own. It is applied to the interior surface of the glass, where it rejects part of the incoming solar energy before it becomes heat in the room. That makes it one of the few envelope upgrades a property manager can carry out on an occupied building without a construction schedule, a permit-heavy glazing replacement, or tenants moving out.

This page covers how we choose a solar film for a commercial property, the data we give architects and owners, and how an install runs. For the full range of commercial films, see our commercial window tinting overview.

Choosing a film

Choosing solar control window film by building

The right solar film depends on what the building needs to look like and how hard the sun hits it. We usually narrow it down by three questions.

  1. How much daylight do the occupants need?

    Open offices, classrooms and medical waiting rooms work better with high light transmission. Solar Gard publishes Panorama HiLite 70 as transmitting 70% of visible light and rejecting 54% of total solar energy on 6 mm clear glass. Maxpro publishes Elite Max 70 at 69% visible light transmission and 45% total solar energy rejected.

  2. Does the exterior need to stay the same?

    Many office parks, retail centers and medical plazas have owner or association standards for how the glass looks. Low-reflectance films keep exterior reflectance low. XPEL Clear View Plus 70, for example, is published at 8% exterior reflectance and 55% total solar energy rejected on 3 mm glass.

  3. Is the problem extreme heat on a few elevations?

    For a west-facing storefront or a warehouse office with unshaded glass, a darker metallic film does more. Solar Gard TrueVue 15 is published at 12% visible light transmission and an SHGC of 0.23 on 6 mm clear glass. XPEL Evening View 15 is published at 15% visible light transmission and an SHGC of 0.24 on 3 mm glass. Note that XPEL tests on 3 mm glass and Solar Gard on 6 mm glass, so the two sets of figures are not a direct comparison.

Mixing films across elevations

Many buildings end up with more than one film: a darker film on the west and south elevations and a clearer film on the north side, chosen so the exterior still reads as one building. Before we recommend any film, we also check the glass type and condition, because some insulated and heat-strengthened units need a particular film class to stay within the glass maker’s guidance.

Where it's used

Solar film for offices, storefronts and schools

  • Office towers and mid-rise offices

    Perimeter offices and conference rooms along curtain wall become usable in the afternoon, and screens are easier to read.
  • Retail storefronts

    Sales floors near the glass stay more comfortable for staff and shoppers, and the film blocks UV that fades displayed goods.
  • Medical and dental suites

    Waiting rooms and operatories near large windows stay comfortable without closing every blind.
  • Schools

    Classrooms with big window walls get less afternoon heat and glare, and installs can be scheduled over breaks.
  • Restaurants

    Patio-facing dining rooms are easier to seat during the hottest part of the day.
  • Warehouses and flex space

    Front offices and clerestory glass on industrial buildings often take direct sun with no shading at all.

Specs

Commercial solar window film specs

Solar Gard TrueVue

SRP rebate eligible
FilmVisible light transmittedTotal solar energy rejectedSHGCUV blockedGlare reduction
TrueVue 3031%0.39>99%n/a
TrueVue 1512%0.23>99%n/a
TrueVue 55%0.21>99%n/a

Manufacturer-published values measured on 1/4" (6 mm) clear glass; results on your windows vary by glass type. Sources: spec sheet

XPEL Evening View

SRP rebate eligible
FilmVisible light transmittedTotal solar energy rejectedSHGCUV blockedGlare reduction
Evening View 2526%0.3999%69%
Evening View 1515%0.2499%83%
Evening View 58%0.1999%92%

Manufacturer-published values measured on 1/8" (3 mm) glass; results on your windows vary by glass type. Sources: spec sheet

Solar heat gain data for architects and energy reviews

Architects, engineers and facilities teams need to compare films on the same basis. For each film we propose, we provide the manufacturer’s published visible light transmission, exterior reflectance, total solar energy rejected, SHGC and UV figures, with the test glass stated. For example, Solar Gard TrueVue 30 is published at 31% visible light transmission, 61% total solar energy rejected and an SHGC of 0.39 on 6 mm clear glass. XPEL Evening View 25 is published at 26% visible light transmission and an SHGC of 0.39 on 3 mm glass, and XPEL also lists its U-factor and emissivity.

If you are weighing film against reglazing, our article on solar window film vs. Low-E glass replacement walks through the trade-offs, and our piece on solar heat gain coefficient explains how to read SHGC on a spec sheet.

Installation

Solar window film installation on an occupied building

Schedule a site survey
  1. STEP 1

    Survey

    We measure every lite, note glass type, condition and any existing film, and identify where lift or upper floor access is needed.
  2. STEP 2

    Proposal

    You get a written proposal with film options, manufacturer data, square footage and schedule. We can price alternates for each elevation.
  3. STEP 3

    Scheduling

    We work after hours, on weekends, or floor by floor so tenants keep working. Film installation is quiet and needs no structural work.
  4. STEP 4

    Installation

    Crews protect furniture and equipment near the glass, clean each pane, and apply film to manufacturer spec.
  5. STEP 5

    Closeout

    You receive warranty documentation. Commercial manufacturer warranties run 12 years for Solar Gard TrueVue, 15 years for XPEL Clear View and 10 years for XPEL Evening View. Both makers also cover glass breakage for 5 years and insulated glass seal failure for 3 years on approved film-to-glass applications, up to $500 per window.

We work directly for owners and property managers, and as a subcontractor to general contractors on tenant improvements and renovations.

Cost

Commercial solar window film cost

Installed rates start at $8.25 per square foot for solar control film, $9.00 for clear ceramic and $11.50 for darker ceramic. The total depends on:

  • Film choiceClear, high-visibility ceramics cost more than standard solar control films.
  • Old filmRemoval adds $4.50 per square foot.
  • AccessUpper floor or lift access adds 15%.
  • Glass layoutMany small lites take more labor than a few large panes of the same total area.
  • ScheduleAfter-hours work and phased installs are planned into the proposal up front.

Commercial solar window film cost per square foot

Installed prices start at $8.25 per square foot. Your written proposal is based on measured glass, film choice and access.

Film gradeInstalled price per sq ft
Clear ceramicFrom $9.00
Darker ceramicFrom $11.50
Solar controlFrom $8.25

Prices as of October 2026, from our bid-tool customer rates. Old film removal adds $4.50 per sq ft; upper-floor or lift access adds 15%.

Removing old solar film from windows

Many Arizona commercial buildings already have film that has turned purple, bubbled or started to peel. That film is no longer doing much, and it makes the building look neglected. We remove it, clean the glass and install new film in the same visit where possible. Removal adds $4.50 per square foot.

We note any existing film during the survey, so removal is priced in the proposal rather than discovered on install day. Once the new film is on, a slight haze for a few days is normal while moisture under the film dries out, and the glass should not be cleaned for the first 30 days. We give the facilities team written care instructions to pass to the window cleaning service.

Commercial solar window film projects

See all window film projects →
  • Phifer SunTex 90 solar screens on a door and sidelight at a Tempe senior living community's memory care unit

    Solar screens in Tempe, AZ

    Desert Marigold Senior Living: solar screens and lobby film

    Tempe · Solar Screens · Solar Window Film ·

    Phifer SunTex 90 solar screens on the doors of the memory care unit, combined with Madico Optivision Reflective 5 window film to cut heat in the lobby.

Related films

Solar film often solves more than heat, but some spaces need a different film. For screen glare in conference rooms, see anti-glare window film. For showrooms where fading is the main concern and the glass needs to stay clear, see UV protection window film. If you are treating your own house as well, our home solar window film page covers residential options and the SRP rebate.

We install commercial solar film across the Phoenix metro and Tucson metro, with crews available Valley-wide. Contact us to schedule a site survey.

Part of our commercial window tinting services; also available as solar window film for homes.

More commercial window tinting films

Service areas

Commercial solar window film installation by city

All service areas →

Common questions

Commercial solar window film questions

Have a question about your glass? Ask us.

How much does solar window film cost for a commercial building?

Our solar control films start at $8.25 per square foot installed, clear ceramic films start at $9.00 and darker ceramic films at $11.50. Removing old film adds $4.50 per square foot, and upper floor or lift access adds 15%. You get a written proposal from measured glass.

Is solar control window film a good investment for an office building?

For buildings with large west or south glass, it is one of the few upgrades that changes how perimeter space feels without replacing glazing. The return depends on your glass, orientation and how the space is used, so we base recommendations on manufacturer data for the films we propose rather than promised savings.

What are some ways to block sun heat from commercial windows?

The main options are exterior shading, blinds or shades, replacing the glazing, and solar window film. Blinds stop heat after it is already inside the room. Film rejects part of the solar energy at the glass and leaves the view open, which is why many owners use it on occupied buildings.

How do you remove old solar film from commercial windows?

We steam or soften the old adhesive, peel the film, then scrape and clean the glass so the new film bonds properly. Removal is priced at $4.50 per square foot on top of the new film. On faded or bubbling film, removal is often the larger part of the labor.

Will solar film change how our building looks from the street?

It depends on the film. Low-reflectance films like Solar Gard Panorama HiLite 70 keep the exterior close to its current look, while darker metallic films such as XPEL Evening View 15 add a mirrored appearance in daylight. We can install a test panel so owners and associations see it in place first.

Can you install solar film on upper floors of a multi-story building?

Yes. We plan lift or upper floor access during the site survey, and that access adds 15% to the installed rate. Most multi-story work is done from the interior, floor by floor, around tenant schedules.

Free consultation

Book a free window tinting consultation

Tell us about your glass and we'll send a written proposal.

(480) 977-6994
  • Arizona: ROC Lic# 333727

By submitting, you agree to receive calls and texts about your request from Total Protection Films. Msg & data rates may apply. Reply STOP to opt out. See our privacy policy.

Licensed, factory-authorized window film installers

  • Arizona: ROC Lic# 333727
  • Solar Gard / Saint-Gobain authorized dealer
  • Armorcoat authorized installer
  • XPEL authorized dealer
  • Madico SafetyShield qualified dealer
  • Full XPEL VISION line installed
  • 25 years of window film experience

Because we're factory-authorized, film is installed to manufacturer spec and carries the manufacturer's warranty.