Total Protection Films

Resources

Architectural Window Film Resources

Architectural window film is the industry term for film made for buildings rather than vehicles: homes, offices, storefronts and public buildings. It covers solar control, security, privacy and decorative products.

These articles look at architectural film choices for high-end homes and commercial properties, including how to keep a building's exterior appearance consistent and how to compare films using manufacturer performance data.

For the films we install, see home window tinting and commercial window tinting.

Brands and credentials

We install XPEL's full VISION line, Solar Gard TrueVue, Panorama and Armorcoat, Madico, Maxpro, and Phifer solar screens. We are a Solar Gard authorized dealer, an Armorcoat authorized installer, a Madico SafetyShield qualified dealer and an XPEL authorized dealer. Manufacturer warranties require installation by an authorized dealer, so the installer's credentials decide whether the warranty applies.

Comparing films fairly

Each manufacturer tests on its own glass. Solar Gard publishes on 1/4 inch (6 mm) clear glass and XPEL on 1/8 inch (3 mm) glass, so a number from one brand is not directly comparable with the other. We show the test glass beside every figure we publish. The numbers worth comparing are visible light transmission, solar heat gain coefficient, total solar energy rejected and exterior reflectance, which decides how the building looks from the street.

Appearance and design intent

Architects and HOAs often care most about exterior appearance. A neutral ceramic film keeps glass close to its original look; a reflective film such as Solar Gard Panorama gives a mirrored exterior and more daytime privacy. For a large home or an office building, film is applied to every pane on a facade at once so the glass reads as one surface. Exterior films, such as XPEL's exterior line, go on the outside of glass that cannot take an interior film, and carry a 5 year film and 2 year labor warranty.

Cost and coverage

Installed prices start at $8.25 per square foot. Removing old film is $4.50 per square foot, and upper-floor or lift access adds 15%. Residential warranties on most of the solar films we install are limited lifetime; commercial terms run 10 to 15 years depending on the film. See our window film warranty page for the documents, commercial solar window film for office and storefront options, and window tinting in Arizona for the areas we serve.

Care after installation

Do not clean new film for 30 days. Slight haze during the first few days is moisture drying out and usually clears on its own. After that, mild detergent and water with a soft cloth keeps it clean, and commercial glass cleaners are acceptable. On a commercial building, give the window cleaning contractor a copy of the care instructions so filmed glass is not scraped.

Some glass should not be filmed at all, or needs the manufacturer's sign-off first. Solar Gard's warranty excludes glass 3/8 inch or thicker, textured, wired and skylight glass, and partial-pane installs. XPEL excludes glass 3/8 inch or thicker, laminated and triple-pane glass, with exceptions listed in its film-to-glass chart. We check each pane against those charts during the site survey.

Free consultation

Book a free window tinting consultation

Tell us about your glass and we'll send a written proposal.

(480) 977-6994
  • Arizona: ROC Lic# 333727

By submitting, you agree to receive calls and texts about your request from Total Protection Films. Msg & data rates may apply. Reply STOP to opt out. See our privacy policy.